May 082016
May’s meeting covered end and sliding miter joints using the Triton router table.
Chris started the meeting with a review of a selection of end joining bits provided by CARB-I-TOOL
Brian then demonstrated tongue and groove and the related spline joint on the router table.
 |
 |
After the drawing of our major raffle (a lovely set of chisels) and an enjoyable tea break, Brian finished off with the sliding miter joint and edging with a melamine veneer.
 |
 |
 |
A two sided veneer trimmer, similar to the one demonstrated by Brian, can be found at Carbatec
